"We purchased our Ercolina Top Bender back in the early 90's and when it came time to upgrade we didn't think twice about buying a new Ercolina Mega Bender. I could never imagine going back to using elbows, with all the welding, grinding and labor involved."

Bob Cavanagh, Mid Island Steel

Angle Roll Capacity Table - CE70

CE 70
Material	Dimensions	Min. Radius	Wall	Roll Type
Pipe	1/2" 3	8" 24"	.095 .216	RT RT-TI
Tube	7/8" 4"	8" 47"	.065 .120	RT RT-TI
Square Tube	1" x 1" 3" x 3"	8" 47"	.065 .120	SR SR-TI
Rectangular tube "Hard way"	1-1/4" x 5/8" 4" x 2"	8" 82"	.065 .120	SR SR-TI
Rectangular tube "Easy way"	1-1/4" x 5/8" 4-3/4" x 1-5/8"	8" 47"	.065 .160	SR SR-TI
Oval tube "Hard way"	2" x 1" 4" x 2"	8" 47"	.080 .118	SR SR-TI
Oval tube "Easy way"	2" x 1" 4-3/4" x 1-5/8"	8" 47"	.080 .125	SR SR-TI
Round solid	1-1/4" 2-3/8"	6" 16"	NA NA	RT RT-TI
Square solid	1-1/4" 2"	6" 16"	NA NA	RS-TI RT-TI
Rectangular solid "Hard way"	1-1/4" x 1/4" 4" x 1/2"	8" 32"	NA NA	RS RS-TI
Rectangular solid "Easy way"	1-1/4" x 3/8" 5-1/2" x 1-1/4"	8" 16"	NA NA	RS RS-TI
Angle leg out	1-1/4 x 1-1/4" 3-1/4"x 3-1/4"	10" 24"	.160 .375	RS RS
Angle leg in	1-1/4 x 1-1/4" 3-1/4" x 3-1/4"	10" 32"	.160 .375	RS RS
T leg out	1" X 1" 4-3/4" X 4-3/4"	8" 24"	.120 .375	RS-TI RS-TI
T leg in	1" X 1" 4-3/4” x 4-1/4”	8" 24"	.125 .375	RS RS-TI
C leg out	1-1/4" 6-1/4"	12" 24"	.125 .250	SR SR-TI
C leg in	1-1/4" 6-1/4"	12" 24"	.125 .250	SR-TI SR-TI
C leg up	1-1/4" 2-3/8"	10" 28"	.060 .125	RS RS-TI
H Profile leg up	4" X 2" 6-1/4" X 2-1/2"	24" 47"		SR SR-TI
H Profile leg in	3-1/4" 6-1/4"	24" 47"		SR SR-TI

Bending capacities based on mild steel
RS = Stand three-roll set
RT = Three-roll tube and solid bar set
SR = Three-roll set, special order
TI = Support shafts for rolls